Energy star products

courtesy : Energy star products

Servers

The EPA released Version 1.0 of the Computer Server specifications on May 15, 2009. It covered standalone servers with one to four processor sockets. A second tier to the specification adding active state power and performance reporting for all qualified servers, as well as blade and multi-node server idle state requirements became effective December 16, 2013. The Version 2.0 Energy Star specification for Computer Servers came into effect on December 16, 2013. The Version 3.0 Energy Star specification for Enterprise Servers came into effect on June 17, 2019

Appliances

As of early 2008, average refrigerators need 20% savings over the minimum standard. Dishwashers need at least 41% savings. Most appliances as well as heating and cooling systems have a yellow EnergyGuide label showing the annual cost of operation compared to other models. This label is created through the Federal Trade Commission and often shows if an appliance is Energy Star rated. While an Energy Star label indicates that the appliance is more energy efficient than the minimum guidelines, purchasing an Energy Star labeled product does not always mean one is getting the most energy efficient option available. For example, dehumidifiers that are rated under 25 US pints (12 L) per day of water extraction receive an Energy Star rating if they have an energy factor of 1.2 (higher is better), while those rated 25 US pints (12 L) to 35 US pints (17 L) per day receive an Energy Star rating for an energy factor of 1.4 or higher. Thus a higher-capacity but non-Energy Star rated dehumidifier may be a more energy efficient alternative than an Energy Star rated but lower-capacity model. The Energy Star program’s savings calculator has also been criticized for unrealistic assumptions in its model that tend to magnify savings benefits to the average consumer.

Another factor yet to be considered by the EPA and DOE is the overall effect of energy-saving requirements on the durability and expected service life of a mass-market appliance built to a consumer-level cost standard. For example, a refrigerator may be made more efficient by the use of more insulative spacing and a smaller-capacity compressor using electronics to control operation and temperature. However, this may come at the cost of reduced interior storage (or increased exterior mass) or a reduced service life due to compressor or electronic failures. In particular, electronic controls used on new-generation appliances are subject to damage from shock, vibration, moisture, or power spikes on the electrical circuit to which they are attached. Critics have pointed out that even if a new appliance is energy efficient, any consumer appliance that does not provide customer satisfaction, or must be replaced twice as often as its predecessor contributes to landfill pollution and waste of natural resources used to construct its replacement.

Heating and cooling systems

Energy Star qualified heat pumps, boilers, air conditioning systems, and furnaces are available. In addition, cooling and heating bills can be significantly lowered with air sealing and duct sealing. Air sealing reduces the outdoor air that penetrates a building, and duct sealing prevents attic or basement air from entering ducts and lessening the heating/cooling system’s efficiency. Energy Star qualified room air conditioners are at least 10% more energy efficient than the minimum U.S. federal government standards.

#heating and cooling systems

#Energy star products

# the Computer Server specifications

#ISBC